|
Re: Over-Driven FT-8 QRM #FT8 QRM
#FT8
Chuck,
If you run one of the RTL $10 dongles, you can select , direct conversion in the driver , and the device will Rx from ~~ 0 to 25 MHz ish , it cuts out the front end and just
Chuck,
If you run one of the RTL $10 dongles, you can select , direct conversion in the driver , and the device will Rx from ~~ 0 to 25 MHz ish , it cuts out the front end and just
|
By
Graham
·
#50998
·
Edited
|
|
Re: Over-Driven FT-8 QRM #FT8 QRM
#FT8
I check my transmitted digital signals (FT8, etc) with a US$30 SDR USB dongle and SDRSharp freeware. The cheapest dongles don't receive below 25 MHz, but that doesn't matter. Put a dummy load on your
I check my transmitted digital signals (FT8, etc) with a US$30 SDR USB dongle and SDRSharp freeware. The cheapest dongles don't receive below 25 MHz, but that doesn't matter. Put a dummy load on your
|
By
Chuck K4RGN
·
#50997
·
|
|
Re: Over-Driven FT-8 QRM #FT8 QRM
#FT8
Its only single tone , no intermod products , don't matter where the alc is set, that's harmonics , due to the aggressive tone switching , mfsk produces a similar set of sidebands , but
Its only single tone , no intermod products , don't matter where the alc is set, that's harmonics , due to the aggressive tone switching , mfsk produces a similar set of sidebands , but
|
By
Graham
·
#50996
·
|
|
PA1SDB uses 200 uW over QO100 Sat link
#opera
#sat
#ao100
Posted to the Opera facebook page's
Today SV8RV did copy my 0.2mW signal in OP05 via QO100. Dish is 2 meter :-)
It was not possible to become decoded with less power [21/9/2019]
Peter,
Posted to the Opera facebook page's
Today SV8RV did copy my 0.2mW signal in OP05 via QO100. Dish is 2 meter :-)
It was not possible to become decoded with less power [21/9/2019]
Peter,
|
By
Graham
·
#50995
·
Edited
|
|
Re: Over-Driven FT-8 QRM #FT8 QRM
#FT8
I suspect too many hams are operating with the SSB compressor on. One advantage of the newer gear is that it supports a defined digital mode where the compressor is always off.
73,
Mark wa4kfz
I suspect too many hams are operating with the SSB compressor on. One advantage of the newer gear is that it supports a defined digital mode where the compressor is always off.
73,
Mark wa4kfz
|
By
Wa4kfz
·
#50994
·
|
|
Over-Driven FT-8 QRM #FT8 QRM
#FT8
All:
The interference caused by over-driven FT-8 signals is concerning. The distortion that shows up on either side of the FT8 watering hole is often stronger than the signal one is trying to copy
All:
The interference caused by over-driven FT-8 signals is concerning. The distortion that shows up on either side of the FT8 watering hole is often stronger than the signal one is trying to copy
|
By
Tony
·
#50993
·
|
|
Re: For Sale: Funcube Pro Plus #FS Funcube Pro Plus
#fs
Barney et all:
The Dongle was sold.
Thank you.
Tony -K2MO
Barney et all:
The Dongle was sold.
Thank you.
Tony -K2MO
|
By
Tony
·
#50992
·
|
|
Re: For Sale: Funcube Pro Plus #FS Funcube Pro Plus
#fs
any takers yet?
By
Barney
·
#50991
·
|
|
For Sale: Funcube Pro Plus #FS Funcube Pro Plus
#fs
All:
I have a Funcube Pro Plus Dongle for sale. Covers 150 kHz ~ 1.9 GHz.
Best offer shipped CONUS.
Tony -K2MO
All:
I have a Funcube Pro Plus Dongle for sale. Covers 150 kHz ~ 1.9 GHz.
Best offer shipped CONUS.
Tony -K2MO
|
By
Tony
·
#50990
·
|
|
Re: vara
#Software
Sorry,
https://rosmodem.wordpress.com
Sorry,
https://rosmodem.wordpress.com
|
By
KC9SGV
·
#50989
·
|
|
Re: vara
#Software
Excellent digital mode.
As fast as Pactor 3
https://www.datv-express.com
KC9SGV
Excellent digital mode.
As fast as Pactor 3
https://www.datv-express.com
KC9SGV
|
By
KC9SGV
·
#50988
·
|
|
vara
#Software
hey youall......what happened to the new vara (any version) software ?
was hoping to at least get a look at it.
david/wd4kpd
hey youall......what happened to the new vara (any version) software ?
was hoping to at least get a look at it.
david/wd4kpd
|
By
David Michael Gaytko // WD4KPD
·
#50987
·
|
|
New release of MULTIPSK (4.40) - DSTAR
#Multipsk
New release of MULTIPSK (4.40) - DSTAR
Pour les francophones: la version en français de ce message se trouve sur mon site (http://f6cte.free.fr). Il suffit de cliquer sur le lien "Principales
New release of MULTIPSK (4.40) - DSTAR
Pour les francophones: la version en français de ce message se trouve sur mon site (http://f6cte.free.fr). Il suffit de cliquer sur le lien "Principales
|
By
Patrick Lindecker
·
#50986
·
|
|
Re: VARA -SAT- Dynamic net facility
#VARA
dg0opk Lists equipment used
[SDR console , has beacon AFC-Lock , specially designed for the Sat
used the band edge CW beacon to lock qrg]
Peak Data Rate: 3500bps
setup using:
TCXO
dg0opk Lists equipment used
[SDR console , has beacon AFC-Lock , specially designed for the Sat
used the band edge CW beacon to lock qrg]
Peak Data Rate: 3500bps
setup using:
TCXO
|
By
Graham
·
#50985
·
|
|
VARA -SAT- Dynamic net facility
#VARA
VARA -SAT- Dynamic net facility
This puts portable operation , from low power non gps locked systems on the table
Latest version , contains an interrogator , which, produces a response from
VARA -SAT- Dynamic net facility
This puts portable operation , from low power non gps locked systems on the table
Latest version , contains an interrogator , which, produces a response from
|
By
Graham
·
#50984
·
Edited
|
|
ARRL/TAPR DCC - Call for Technical Presentations & Papers
#digital
2019 ARRL/TAPR DCC
(Digital Communications Conference)
Detroit, MI (near airport)
September 20 - 22
Call for Technical Presentations & Papers
Technical Presentations & Papers are solicited
2019 ARRL/TAPR DCC
(Digital Communications Conference)
Detroit, MI (near airport)
September 20 - 22
Call for Technical Presentations & Papers
Technical Presentations & Papers are solicited
|
By
Mark Thompson
·
#50983
·
|
|
Re: where can I find remote controlled relay board ?
#digital
I purchased a Denkovi SNMP12 a few years ago that will probably do what you want.?? It has 12 SPDT relays (up to 15A), 8 ADC inputs (0-10V) and 8 digital inputs
I purchased a Denkovi SNMP12 a few years ago that will probably do what you want.?? It has 12 SPDT relays (up to 15A), 8 ADC inputs (0-10V) and 8 digital inputs
|
By
Joe
·
#50982
·
|
|
Re: New VARA HF v3.0.2
#VARA
Andy
Yes its bit clunky , but , the intent was/is to provide , fast one-2-one comms , with file transfer ,
good reports are being received from the E-Com users , a new version overcomes
Andy
Yes its bit clunky , but , the intent was/is to provide , fast one-2-one comms , with file transfer ,
good reports are being received from the E-Com users , a new version overcomes
|
By
Graham
·
#50981
·
|
|
PR8KW Brazil <> Italy IS0GRB VARA E-malil over QO-100
#VARA
#sat
IS0GRB Winlink Server on QO-100 (Dial 10489635.0 USB)
PR8KW
Successful test of E-mail and File transfer,
have been completed by PR8KW ,
using the WIN-Link ground station provided by
IS0GRB Winlink Server on QO-100 (Dial 10489635.0 USB)
PR8KW
Successful test of E-mail and File transfer,
have been completed by PR8KW ,
using the WIN-Link ground station provided by
|
By
Graham
·
#50980
·
Edited
|
|
Re: where can I find remote controlled relay board ?
#digital
Hi Fred
Perhaps units from RemoveQTH is what you are looking for: https://remoteqth.com/hf-switching-and-matching.php
73
Bo, OZ2M, www.rfzero.net
Hi Fred
Perhaps units from RemoveQTH is what you are looking for: https://remoteqth.com/hf-switching-and-matching.php
73
Bo, OZ2M, www.rfzero.net
|
By
Bo, OZ2M
·
#50979
·
|